THE VEHICLE
| Mercedes-Benz Sprinter 416 (4x2) high roof 4250mm wheel base |
| Modifications and special adjustment |
| Automated brake system |
| Enhanced back axle stabilizer. |
| Off-road capability. |
| Enhanced accumulators. |
| Central accumulator switch. |
| Heated windows. |
| Fog lights. |
| Differential blockage. |
| Hydraulic seat for the driver. |
| Air condition system. |
| Light desk. |
MODIFICATION OF THE ROBOT COMPARTMENT
Air condition operation options
• 24V vehicles electric system.
• Generator or 220V external source.
Plating
THE FLOOR:
A 10-18 mm layer of plywood, coated with 2-3 mm layer of PVC.
The entire upper PVC layer consists of one piece which will
“climb” up all the walls to a height of about 50 mm
ROOF AND WALLS:
The entire roof of the vehicle will be coated with the
following layered structure:
• First layer: 25-30 mm insulation.
• Second layer: 4-6 mm plywood covered with “sky”, including
the rear and side doors, the internal wheel housing, including
covering the door frames and corners and separate openings
for the rear lights, so as to enable replacement of rear lights
from inside the vehicle.
• The roof sections (as few as possible) will be joined with
metal strips.
SEATS:
Rotating central chair
New upholstered vehicle chair including: chair cover, the possibility to move the chair backwards and forward, turning aside around the axis, adjustable back, adjustable and folding handles, safety belt.
Equipment Storage Cabinets
Cabinets for storage of the equipment and tools. Their dimensions and location are according to the needs and parts to be stored.
The cabinets will be constructed of Aluminium 1.2 to 1.5 mm, and will be attached to the structure by a thrust or regular screw, at minimum intervals of every 12 cm.
The panels of the drawers - 3 mm aluminium.
The drawers in the cabinet will move on a metal track. The movement of the tracks will be by means of ball bearings (not a smooth track), with a stop device at the forward end
Each drawer will be designed for a weight of at least 50 KGs.
Each cabinet or drawer will have an opening handle a lock and key. There will be a master key which will and locker all cabinet sand drawers in the vehicle.
The interiors of the cabinets and drawers will be covered with carpeting to prevent noise and friction.
The cabinets should be anchored to the vehicle according to the strength required by the type of the work, as well as in the case of a head-on collision.
The cabinets will be installed so that it will be possible to transfer them to another vehicle of the same type without difficulty (modular design).
All closets and devices shall be painted with grey electrostatic paint.
The place intended for explosives will be an internal box made of aluminium 2 mm wide, with the external dimensions of 700X290X100 mm, with the following internal division:
At the place intended for the cartridge cases, there will be an internal box, similar to the one without the internal division.
[...]
See Technical Data (PDF) for detailed information
